Important - RedMax CHT220 Manual De Instrucciones

5. For safe operation
care should also be taken to constantly
look around or otherwise check for the
presence and locations of other people
working so as to maintain a distance
between each person sufficient to ensure
safety.
2. Check the condition of working area to
avoid any accident by hitting hidden
obstacles such as stumps, stones, cans, or
broken glass.

IMPORTANT

Remove any obstacle before beginning work.
3. Inspect the entire unit for loose fasteners
and fuel leakage. Make sure that the
cutting attachment is properly installed and
securely fastened.
■ STARTING THE ENGINE
1. Keep bystanders especially children, and
animals at least 15 m (50 ft) away from the
operating point. If you are approached,
immediately stop the engine.
2. The product is equipped with a centrifugal
clutch mechanism, so the cutting
attachment might begin to rotate as soon
as the engine is started. When starting the
engine, place the product onto the ground
in a flat clear area and hold it firmly in
place so as to ensure that neither the
cutting part nor the throttle come into
contact with any obstacle when the engine
starts.
WARNING
• Never place the throttle into the high-
speed position when starting the
engine.
• Never start the engine at the cutting
attachment side.
3. After starting the engine, check to make
sure that the cutting attachment stops
rotating when the throttle is moved fully
back to its original position. If it continues
to rotate even after the throttle has been
moved fully back, turn off the engine and
take the unit to your authorized RedMax
servicing dealer for repair.
■ USING THE PRODUCT
IMPORTANT
Cut only materials recommended by the
manufacturer. And use only for tasks
CHT220/CHT220L
explained in the manual.
1. Grip the handles firmly with both hands
using your whole hand. Place your feet
slightly apart (slightly further apart than the
width of your shoulders) so that your
weight is distributed evenly across both
legs, and always be sure to maintain a
steady, even posture while working.
2. Maintain the speed of the engine at the
level required to perform cutting work, and
never raise the speed of the engine above
the level necessary.
3. If the unit starts to shake or vibrate, turn off
the engine and check the whole unit. Do
not use it until the trouble has been
properly corrected.
4. Keep all parts of your body away from
rotating cutting attachment and hot
surfaces.
5. Never touch the muffler, spark plug, or
other metallic parts of the engine while the
engine is in operation or immediately after
shutting down the engine. Doing socould
result in serious burns or electrical shock.
6. While operating the machine be always
sure of a safe and secure operating
position especially when using steps or a
ladder.
• IF SOMEONE COMES
1. Guard against hazardous situations at all
times. Warn adults to keep pets and
children away from the area. Be careful if
you are approached. Injury may result from
flying debris.
2. If someone calls out or otherwise interrupts
you while working, always be sure to turn
off the engine before turning around.
■ MAINTENANCE
1. In order to maintain your product in proper
working order, perform the maintenance
and checking operations described in the
manual at regular intervals.
2. Always be sure to turn off the engine
before performing any maintenance,
checking procedures or working on the
machine.
(1) Check ok!
WARNING
The metallic parts reach high
temperatures immediately after stopping
the engine.
3. When replacing the cutting attachment or
U
S
US-7