Mopar 82211438 Serie Instrucciones De Instalación página 5

d. Remove the front portion of the connector from the connec-
tor housing. This portion of the connector aligns the terminals
properly within the connector housing.
e. Route the Purple/White wire from the hood switch harness
through the secondary lock, through the weather seal and into
the terminal 3 (G70 circuit) slot of the connector housing.
Pin 3 (G70 circuit)
f. Reinstall the front portion of the connector, observing
that all terminals are seated correctly and are in the right
direction. Reinstall the weather seal and the secondary
lock.
g. Reinstall the connector into the TIPM.
Wire End View
5 of 9