Carry - Stanley Compulevel Guia Del Usuario

47855 CompuLevel

Carry

CARRY
COMPULEVEL's CARRY function allows you to measure elevations at
virtually any location, no matter how distant from the starting reference.
To use the CARRY function:
1) At the starting benchmark (reference), press and hold the MARK key
and ZERO key together for two seconds. The word 'CAry' will alternate
with [0] on the display. Hold the measurement module steady to zero
the CARRY function. This will also zero the set up.
2) Move the measurement module to a convenient location within the
single set-up limit. Momentarily press the HOLD key to store elevation.
3) Leaving the measurement module in place at its 'hold' location, move
the base unit toward the final destination and establish the second
set-up location.
4) Press and hold the ZERO key for two seconds at the measurement
module 'hold' spot while keeping it steady. The word 'CAry' will again
appear on the display. When 'CAry' stops flashing, you will be in the
CARRY function where upper display 'C----' and measurement display
alternate.
Repeat steps 2 through 4, over any number of set-ups. Once in the CARRY
function, momentarily press the zero key thereafter with each base unit
move.
To exit the CARRY function within any set-up, press and hold the ZERO key
for two seconds.
Notes: Outside the CARRY function, elevations will be referenced to the
HOLD/ZERO elevation for that set-up, but you may re-zero anywhere. To
re-enter the CARRY function at any elevation within the set-up, simply
momentarily press the HOLD key, then press the ZERO key for two
seconds.
The CARRY function can be used to quickly establish a remote elevation
with an assistant moving the base unit. The base unit may be placed and
held upright if kept upright after the ZERO key has been pressed for the
set-up.
6/11/07 11:14 Page 16
Compulevel TM Measurement system • 16