Quick Start - Stanley Compulevel Guia Del Usuario

47855 CompuLevel

Quick Start

Although most COMPULEVEL
routinely necessary in their work, we recommend that you try all
COMPULEVEL TM
capabilities. The use of all COMPULEVEL
this guide.
These quick start pages, however, show the operation of a few basic
functions that most users will employ and they will help you gain
confidence in working with all of COMPULEVEL's functions.
To take basic elevation measurements with COMPULEVEL
1) raise the lower door of the base unit, remove the measurement module
and lay the base unit on its back on the floor or ground.
2) Pull from the reel ample cord to cover the area to be measured.
Momentarily press the ON/OFF key to turn the unit on. The ON/OFF key
will click when pressed and the unit will emit a double a beep.
3) Place the measurement module on a nearby horizontal surface. When
the reading has settled, it will emit two quick beeps. Then, press and
hold the ZERO key for two seconds. Keep the measurement module
steady until the numeral zero appears on the display. The unit is now
zeroed on this reference point.
4) Move the measurement module to a different elevation (from a table to
the floor, for example). It will display the difference in elevation from
the first location to the second. Move it to a third location and it will
display the difference in elevation from the first location to the third
(current) location.
5) Momentarily press the ON/OFF key to shut off the unit. Reel in the
cord, dock the measurement module in its storage compartment and
lock the door.
WARNING: READ AND UNDERSTAND THIS ENTIRE USER'S GUIDE
BEFORE USE.
7 • Compulevel TM Measurement system
6/11/07 11:14
TM users will use only those functions
functions at least once to become familiar with its
Page 7
TM functions is detailed in
TM :