Water Connection - Emerson CWT-00 Instalacion, Cuidado & Uso

Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
2
INSTALLING THE WATER TANK
A
Property Damage: All tubes must be cut
B
White Tape
Property Damage: Do not pinch or break tubing.
Do not distort the last 1 inch of tubing.
Pull on connection to ensure fully engaged.
3

WATER CONNECTION

A
Brass Nut
Property Damage: Join remaining tube
to cold water supply only. Water supply
valves must not prevent backward flow.
B
White Tape
To chilled water
tank "Inlet"
To remove tube(s) or plug from quick-connector,
depress the release ring and gently pull away.
Inlet
squarely with no burrs.
Outlet
From filter or
water supply
Ferrule
Brass Insert
To hot water
dispenser
I I
Attach supplied quick connect elbow to
end of supplied white 1/4" tube.
I I
Attach quick connect elbow to water
Inlet on front of chilled water tank.
I I
Measure distance from water inlet on
chilled water tank to water supply valve
(See Step 3). Carefully trim white 1/4"
tube, allowing ample slack in tubing.
I I
Attach supplied quick connect elbow to
end of supplied blue 1/4" tube.
I I
Attach quick connect elbow with blue
tube to water Outlet on front of chilled
water tank.
I I
Measure distance from the chilled
water tank outlet to water supply line
on faucet. Carefully trim blue tube to
correct length.
I I
Using quick connect elbow, connect
remaining end of blue tube to unmarked
copper tube coming from faucet.
I I
Install a T-fitting (not included)
onto the cold water supply line.
I I
Install dedicated water control valve
with 3/8" compression fitting.
I I
Install brass nut, ferrule and tube insert
on to white 3/8" tube which runs from
filter or "Y" quick-connect fitting.
I I
Insert the white 3/8" tube into the 3/8"
compression fitting and tighten.
I I
Remove existing "Y" quick-connect
fitting and discard.
I I
Connect white 3/8" tube from the
filter or water supply into the supplied
"Y" quick-connect fitting until it stops.
I I
Insert 1/4" white tube from tank inlet
From filter or
into the 3/8" to 1/4" quick-connect fitting.
water supply
I I
Identify copper HOT water tube,
which is marked with white tape.
Install that tube into the 3/8" to 1/4"
quick-connect fitting.
5