Emerson CWT-00 Instalacion, Cuidado & Uso página 6

Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
4
FILL TANK & CONNECT POWER
A
Property Damage: Before plugging in
chilled water tank, check for leaks in all
water supply connections.
B
Property Damage: A standard grounded
outlet is required under the sink.
Do not use an extension cord set with
The SinkTop Switch
electrical outlets, which allows the chilled water tank, hot water dispenser and food
waste disposer to be connected to the same electrical outlet. The chilled water tank
should not be plugged into the SinkTop Switch. The chilled water tank must be connected
directly into the open wall outlet. For more information visit www.insinkerator.com.
6
the chilled water tank.
™ from InSinkErator
I I
Turn on the cold water supply.
I I
Depress the cold faucet handle
and hold it until water flows from
the spout.
I I
Allow water to run for at least
60 seconds after water begins to
flow from faucet.
I I
Depress the hot water handle until
water flows smoothly.
I I
Check all connections to ensure they
are tight and that there are no leaks.
I I
Plug in chilled water tank
and hot water dipenser tank.
I I
Prior to drinking water from the chilled
water tank, run the water for at least 5
minutes to flush lines.
Allow up to 60 minutes for
water to reach target temperature.
Gurgling or hissing is normal
during the initial heating cycle.
® conveniently switches power between two