Rosenbauer HEROS Titan Pro Información Para El Usuario página 15

3.2 Visor replacement (face shield)
First, the two screws (hexagonal socket) left and right helmet side must be removed.
The visor should then be removed from its anchorage.
A new visor is then inserted onto the seating bolts and the supports pushed into the
plastic lugs in the reverse sequence. These are then secured by the holding screws.
Take care that the enclosed washers sit properly and all screws are securely
tightened (both face shield and eye shield).
3.3 Visor replacement (eye shield)
3.4 Ear Cover replacement
1
First, remove the inner harness from the helmet shell
(see point 2.2.3, adjustment of the wearing height).
Then, remove both screws left and right (hexagonal
socket) at the pivot point of the visor.
Replace the visor and reassemble in the reverse
sequence.
Remove the ear cover following step 1-2 as shown
in above figure, reassembling using the reverse sequence.
2
HEROS Titan Pro – Rosenbauer
EN
15