AVIRE TOC DAU Guia De Instalacion página 6

9. Programming
This connector is used to modify the firmware of the equipment. Contact our technical
service staff for more information
A) External Speaker
The External Speaker output provides additional functionality,
allowing the installer to place an individual speaker unit closer
to the area where the user is likely to be situated.
B) External Microphone
A) External Speaker B) External Mic. C) External Pictograms D) 12v or 24v selector
C) External Pictograms (LEDs)
The cable for the connection to the external pictograms in
the elevator cabin, is supplied together with the equipment.
Connect this cable to illuminate the pictograms located on the
elevator COP.
Programming the TOC DAU
The TOC DAU is configured via the DCP. Please ensure the DCP is installed and configured
correctly first. The DCP can be configured remotely via the Avire Hub or via SMS.
1. The Avire Hub
+ All settings can be configured remotely via the Avire Hub
+
The link to the Avire Hub is avirehub.avire-global.com Please contact your local sales
office for information on how to get access to the Avire Hub.
2. SMS Commands (Send to DCP sim number connected to the CANbus)
+ All TOC DAU parameters can be remotely configured via SMS.
+
Each SMS message should begin with 'Pin1234' which is the access code to read or to
make any changes to the configuration of the DCP.
+
You can modify or check several parameters in each SMS by separating them with
commas ","
The External Mic. provides extended
microphone functionality, allowing the
installer to place a microphone closer to the
area where the user is likely to speak. The
external mic. (supplied with equipment) is
prewired at factory.
Please check connection if there is an error.
D) External Pictogram (LEDs) Voltage Selection
This switch allows you to choose either 12V or 24V output for
the external pictogram LEDs (default 12V).
6