Use Of The Device - T.I.P. Cross Tools TRAVELBOX 500 V Instrucciones Para El Manejo

Charging information & charging options
No. Type of charging
cable
AC mains adapter
(normal)
I AC mains adapter
(fast)
II DC cable (KFZ)
III Solar cable (MC4)
3. The small LED charge indicator (15) on the front of the device lights up red dur-
ing charging when the device is connected to a power source for charging. The
LED colour changes to green as soon as the device is fully charged.
4. You can check the charging status or charging progress by means of the LED
display (10) on the side. The display is only active when the (AC) ON/OFF switch
of the Schuko sockets is switched on. The device is fully charged when all 6 bars
light up green.
5. Do not continue to charge the battery after it has been fully charged or the charg-
ing process has ended. This may negatively affect the life of the lithium battery.
With the two charging ports (9 & 16) and the CrossTools quick charger (CHARGE-
BOX 180 / Art. No. #68063), the charging time can be reduced to up to 5.2 hours.
The TRAVELBOX 500 V can also be charged with a slower standard 90 Watt
charger (this charger is not included). In addition, it can be charged with a solar panel
or in the car / truck via charging port (9).
5.2

Use of the device

1. Open the front and rear covers.
2. Switch the ON/OFF switch of the Schuko sockets and/or the DC connections to
"ON".
3. Connect consumer and start if required.
(take maximum power from the technical data)
4. If you wish to stop the power supply, switch off the consumer, disconnect it from
the device and set the ON/OFF switch to "OFF".
5. While the device is not in use, set both switches of the device to "OFF". This pre-
vents self-discharge.
6. Close the front and rear covers again.
The covers fitted to the device must always be kept open during charging
and/or operation of the device so that sufficient internal cooling is ensured.
The cooling of the device is controlled by temperature, i.e. the integrated
cooling fan can be switched on during charging and power output depending
on the load and generate corresponding working noises.
16
Current voltage charging cable Charging
prim. 230 V~ / sec.19 V DC
prim. 230 V~ / sec. 12.8 V DC
12 V / 24 V
12 – 30 V
II
I
Translation of the original operating instructions
capacity
90 watt
180 watt
42 watt
120 watt / 18 V
Solar panel)
.
I
6
Charging
duration
8.4 h
5.2 h
13.2 h
5.8 h
III