Rolling Up The Legs Of Jeans - Toyota SUPER JEANS Serie Manual De Instrucciones

6
Place the handle in position (see diagram) and
sew in place on the wrong side.
1
2
To finish off the bag, thread ribbon or a scarf
through the belt loops & tie in a bow.

■ Rolling up the legs of Jeans

1
Cut jeans legs to a suitable length.
2
Cut out 2 pieces of the fabric of your choice.
(a) Measure around the cut edge of jeans leg.
(b) Cut out 2 fabric pieces.
Length: jeans cut edge + 2cm for seam
allowance
Width: 10 - 15cm or as desired including
seam allowance
Fold each fabric piece in 1/2 lengthwise, right
sides together, pin and sew down each seam,
1cm in from raw edge. Press seam flat and
open.
(a)
1
(b)
2
3
1cm 1cm
Cut edge
1
2 Jeans cut edge
3 Width
Handle position
1
2 Wrong side
4
5
3
6
1cm
4 Wrong side
5 Fold
6 1/2 of Jeans cut edge
3
Pin each fabric piece to each jeans leg, right
sides together. Match fabric piece seam to
inside leg seam of jeans. Remove the extension
table ready for free arm sewing.
Position the jeans leg around the free arm and
sew 1cm up from the bottom raw edge.
4
Pull down the attached piece. Press.
Overcast the raw edges. Turn up 1cm around
the bottom of the fabric piece on to the wrong
side. Press.
Pin up the bottom fold of the fabric piece to lie
along the seam. Sew around the attachment
0.5cm down from the seam edge.
Wrong side
1
5
Turn the jeans through to the right side. Fold up
the contrast piece as desired. Press if required.
Make sure both leg attachments are the same.
1
2
1 Right side
1cm
2 Wrong side
1
0.5cm
2
0.5cm
2 Right side
5
EN