Publicidad
Idiomas disponibles
Idiomas disponibles
5. Cart Beam, Triangle
Strengthening
Wedge,
Tank Exclusion
Bar
- Screw 2 AA screws into the top front of each side panel as shown below.
Leave screw heads protruding
approximately
1/8-inch
above panel surface.
- Slide the 2 notches in each end of the cart beam into place over the protruding
screws..
- Tighten the screws to secure the cart beam to the side panels.
- Attach
1 Triangle
Strenthening
Wedge
to each front corner of the cart with 4 AA screws as shown.
- Attach
the Tank Exclusion Bar from the bottom
panel to the back panel
using 2 FF screws as shown in both
figures on this page.
6. Drip Tray
Attach
the drip tray to the tops of the side panels with 4 AA screws as shown.
\
23
Publicidad
