Emerson SWEEP ECO Wi-Fi CF279BS00 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.3
Remove one of the three #6-32 x 3/8" Pan Head
Screw with Lockwasher from the Motor Assembly Hub
(Figure 3).
Retain the #6-32 x 3/8" Pan Head Screw with
Lockwasher for future use.
Loosen the remaining two #6-32 x 3/8" Pan Head
Screws with Lockwashers (Figure 3).
3.4
Place the 2-pin motor assembly connector through the
large center hole of the Lower Housing (Figure 4).
Position the Lower Housing key hole slots onto the two
loosened screw heads.
Rotate the Lower Housing clockwise to engage the two
screws.
NOTE: Verify that the serrated washers are not
trapped between the Lower Housing and the Motor
Assembly Hub.
Reinstall the previously removed #6-32 x 3/8" Pan Head
Screw with Lockwasher (Figure 4).
Retighten all three #6-32 x 3/8" Pan Head Screws with
Lockwashers to securely attach the Light Kit Housing
Assembly to the Motor Assembly Hub (Figure 4).
A spare #6-32 x 3/8" Pan Head Screw with Lockwasher
is in the hardware bag, if needed.
Carefully turn the partially assembled ceiling fan
right side up and position the fan on the styrofoam in
preparation for additional assembly.
3.5
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 8" Downrod (Figure 5).
Remove the Pin from the 8" Downrod, then remove the
Hanger Ball (Figure 5).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.12.
Note: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
(Continued)
LOOSEN TWO #6-32 x 3/8"
PAN HEAD SCREWS
W/LOCKWASHERS
Figure 3
LOWER
HOUSING
Figure 4
PIN
PHILLIPS HEAD SET SCREW
Figure 5 (LOOSENED)
6
REMOVE & RETAIN ONE
#6-32 x 3/8" PAN HEAD
SCREW W/LOCKWASHER
REINSTALL ONE #6-32 x 3/8"
PAN HEAD SCREW
W/LOCKWASHER
RETIGHTEN TWO
#6-32 x 3/8" PAN
HEAD SCREWS
W/LOCKWASHERS
GREEN GROUND WIRE
8" DOWNROD
HANGER BALL
ETL Model No.: CF279