Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User's Manual
For the Washdown Rated Stainless Steel Wall Mounted Fan
1.Located a wall stud secure and solid enough to hold the weight
of the base assembly. Carefully located and mark the center of
wall stud. If you do not have a solid structural framing member
at that location then you must provide an adequate alternative
for mounting the fan.
2.Place mounting bracket against the wall centered with the
centerline of the wall stud and 4 holes.
3.Drill 4 holes on the wall and secure bracket to wall using 4 lag
screws（not provided）.
If mounting on a concrete wall, be sure to locate a structurally
solid and secure location to hold the weight of the fan assembly
and use suitable concrete anchors (not provided ) to mount the
base to the wall.
62.8mm
113.6mm
4.Remove the 2 bolts, washers and nuts from the mounting
bracket.
5.Align the holes on the mounting bracket with the holes in the
motor flange on the motor assembly.
6.Insert the bolts and replace the washers and nuts removed in
step 4.
7.Tighten the position bolt and nut.
CAUTION: BE SURE TO SECURE THE KNOB.
Washdown Rated Stainless Steel
Pedestal and Wall Mounted Fan
8.Removed the 4 nuts, spring washers and flat washers from
9.Carefully slide the rear grille over the bolts.
10.Secure with the flat washers, spring washers and nuts
11.Carefully slide the blade assembly over the shaft and align
12.Tighten the blade assembly (16) with the hex head screw
NOTE: Keep the hex driver for future use.
CAUTION: DO NOT ALTER THE ANGLE OF THE BLADES.
13.Hang front grille on top rib of rear grille by utilizing the hook.
14.Snap the front grille into the rear grille to secure.
5
the bolts around the motor shaft.
removed in Step 8.
the inner hex head driver provided with the slot on the shaft
of the motor.
using the hex head driver provided with the fan.
Publicidad
Tabla de contenido
