Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User's Manual
Figure 3
230V/60Hz
Connected to Power Ground Wire (Green)
BROWN
Connected to Power Line Wire (Black)
YELLOW
Connected to Power Neatral Wire (White)
●
BLACK
BLUE
Insulated with the connector, avoid the living parts touching the shell
ORANGE
RED
Connected together and insulated with the connector,
●
avoid the living parts touching the shell
WHITE
Table1 Plug and socket
Wiring 115V, according to the user socket, you can choose 5-15P, 5-20P, 5-30P,5-50P.
Wiring 230V, according to the user socket, you can choose 6-15P, 6-20P, 6-30P,-50P.
MAINTAINANCE AND CLEANING
Parts replacement and troubleshooting to be
performed only by qualified personnel.
Do not depend on any switch as the sole
means of disconnecting power when installing
or servicing the fan. Failure to do so may result
in fatal electrical shock.
CAUTION: There is no user maintenance part except regular
cleaning as following description. All other servicing or mainte-
nance should be performed by qualified service personnel.
TROUBLESHOOTING
If your fan fails to operate, please follow these Instructions:
1. Make sure the fan is plugged in and the electrical outlet is working properly.
2. Check for any obstruction. If you find an obstruction, turn the fan "OFF". Unplug the fan and carefully remove the obstruction.
3. Plug the fan in and turn it on again and see if it resumes normal.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR FAN, PLEASE DO NOT ATTEMP TO OPEN OR REPAIR THE FAN
YOURSELF. DOING SO COULD CAUSE DAMAGE OR
PERSONAL INJURY. Always consult the authorized dealer or certified electrician for further action.
Washdown Rated Stainless Steel
Pedestal and Wall Mounted Fan
TO MOTOR
1.To clean the fan, use a soft damp cloth. Wipe down with a dry
cloth. Do not use cleaners that are harmful to paints or plastics.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners,
etc., which are dangerous and will damage the air circulator.
2 The propeller, guard, and motor should be cleaned periodically
to prevent overheating, and/or operating in an imbalanced
condition.
3. If cleaning requires the removal of a guard, remove only the
front guard and re-install when finished in its originally installed
position. Do not repair propeller if it becomes damaged.
The propeller is accurately balanced at the factory and should
be replaced if damaged.
4. Do not bend the blades.
5. Motor is permanently lubricated.
7
BLUE
BLACK
BLACK
ORANGE
WHITE
WHITE
GROUND TO
SWITCH BOX
230 VOLTS
LINE IN
plug
Publicidad
Tabla de contenido
