Fixing Malfunctions - NEFF T43D1 N Instrucciones De Uso

Fixing malfunctions

Display
Malfunction
none The electric power supply
has been interrupted.
The appliance has not
been correctly connected
according to the
connection drawing.
Electronic system
malfunction.
E flashes
The control panel is damp
or an object is resting on it
EÖ +
Electronic system
number/ malfunction
p + number/
 + number/
F0/F9
There is an internal error
in the system
F2
The electronic system has
overheated and the
corresponding hotplate
has been switched off
F4
The electronic system has
overheated and all the
hotplates have been
switched off
60
Malfunctions are generally caused by minor faults.
Before contacting Technical assistance, ensure you
have read the following recommendations and
warnings.
Measure
Use other electrical appliances to check if there has been
a break in the electric power supply.
Check that the appliance has been connected correctly
according to the connection drawing.
If the checks above do not remedy the malfunction,
contact technical assistance.
Dry the control panel area or remove the object.
Disconnect the cooking hob from the mains. Wait a few
seconds before connecting it again.
If the indication continues, notify the technical assistance
service.
Disconnect the cooking hob from the mains. Wait a few
seconds before connecting it again.
If the indication continues, notify the technical assistance
service.
Wait until the electronic system has cooled down
sufficiently. Then press any symbol on the hob.
If the indication continues, notify the technical assistance
service.
Wait until the electronic system has cooled down
sufficiently. Then press any symbol on the hob.
If the indication continues, notify the technical assistance
service.