Installing the Light Kit
CAUTION
To Reduce The Risk Of Electric
Shock, Disconnect The Electrical Supply
Circuit To The Fan Before Installing Light
Kit.
REMEMBER The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping.
Please follow these steps to
complete the installation of your fan and
light. TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1. Remove 1 of 3 screws from the mounting
ring and loosen the other 2 screws(Do not
remove).(Figure 17)
2. Place key holes on the light kit plate over the
2 s crew s previous ly loos ened from the
mounting ring, turn light kit plate until it locks
in place at the narrow setion of the key holes.
Secure by tightening 2 screws previously
l o o s e n e d a n d t h e o n e p r e v i o u s l y
removed.(Figure 17)
3. Remove 1 of 3 screws from the light kit plate
and loosened the other 2 screws(Do not
remove). Connect white wire from motor to
white wire from light kit. Connect black wire
from motor to black wire from light kit.(Figure
18)
7
4. Place key holes on the light kit over the 2
screws previously loosened from the light kit
plate, turn light kit until it locks in place at the
narrow setion of the key holes. Secure by
tightening 2 screws previously loosened and
the one previously removed.(Figure 18)
5. Place the 3 bulbs (60 Watt, included) into
the light kit.(Figure 19)
6. Remove the rubber washer, metal nut, metal
cap and finial from the light kit assembly.
Place glass shade over the light kit stem,
secure with the rubber washer, metal nut,
metal cap and finial previously removed. Do
not over tighten.(Figure 19)
7. Restore power and your light kit is
ready for operations.
Mounting ring
Light kit plate
Figure 17
Bulb
Screw
Figure 19
Black
wire
Light kit
plate
White
wire
Light kit
Screw
Figure 18
Light kit
Glass shade
Rubber Washer
Metal Nut
Metal Cap
Finial