Making The Electrical Connections; Finishing The Installation - HAMPTON BAY Victoria El Manual Del Propietario

Making the Electrical
Connections
Remember to shut off the power.
Follow the steps below to connect the fan to
your household wiring. Use the wire nuts
supplied with your fan. Secure the
connectors with electrical tape. Make sure
there are no loose strands or connections.
1. Connect the fan supply (black) wire to the
black ceiling supply wire. (Figure 11)
2. Connect the neutral fan (white) wire t o
the w hite neutral wire from the ceiling .
(Figure 11)
3. Connect the fan ground wire (green) and
the mounting bracket ground wire (green) to
the ground wire from the ceiling
11)
4. After connecting the wires, spread them
apart so that the green and white wires are
on one side of the outlet box and the black
wires is on the other side.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR OTHER PERSONAL INJURY.
MOUNT FAN ONLY ON AN OUTLET BOX OR
SUPPORTING SYSTEM MARKED
ACCEPTABLE FOR FAN SUPPORT.
5
SUPPLY CIRCUIT
. (Figure
BLACK
BLACK
Diagram indicates optional light kit wiring.
Figure 11

Finishing the Installation

1. Tuck connections neatly into ceiling outlet box.
2.Remove one screw from the mounting bracket
Ground
and loosen the other screw around 1/4".
Conductor
3. Align the canopy up to ceiling and over the
Outlet Box
loose screw. Place the canopy into key hole and
rotate canopy clockwise. (Figure 12)
Green
Ground
4. Secure the canopy by using previous removed
Lead
screw and loosened screws.
Ground to
5. Place the canopy cover to the canopy and
Downrod
rotate canopy cover clockwise until it is locked
into right position.(Figure 12)
WARNING
MAKE SURE TAB AT BOTTOM OF HANGER BRACKET
IS PROPERLY SEATED IN GROOVE OF HANGER BALL
BEFORE
ATTACHING CANOPY TO BRACKET. FAILURE TO
PROPERLY SEAT TAB IN GROOVE COULD CAUSE
DAMAGE TO ELECTRICAL WIRING.
WHITE
WHITE
Figure 12
Outlet box
Mounting
bracket
Screw
Lead Wires
Ball/Downrod
Assembly
Canopy
Canopy
cover