NZI Helmets MAD El Manual Del Propietario página 6

O W N E R S
RING CLOSURE
To adjust the closure, place the strap inside the
rings (E), go around the ring and insert it in the
other (F). Close it with the adjustable peak until
you hear a ''click'' (G).
REMOVING / FITTING THE INTERNAL LINING
-Dismantling: Removing the side pad by first
pulling the front end buttoned (H) and then from
its bottom and to remove it from its housing (I).
Then remove the center hap by pulling the fixing
systems located on the back of the Hull and after
the front (J).
-Assembly: Follow the steps described above in
reverse.
GLASSES HOLDER
To hold the glasses, pull the pressure bracket (K),
put them on and reverse the action until you
hear a ''click''.
VISOR
Visor care guidelines:
Clean it only with water and neutral soap. To dry
the visor it is not necessary to rub; dabbing will
do. We strongly recommend you to avoid the
use of any kind of solvents, alcohol or abrasive
products on the visor. It is recommended to
GB
M A N U A L
replace the visor when scratches or marks appear
during the use; they can impair your view.
PEAK
If you have a peak, you can remove it by pulling it
until the pressure brackets (L) are release.
To readjust it, carry out the reverse action until
you hear a ''click'' and verify that it is firmly
attached.
6