Plug Pack Charger Assembly; Fitting And Removing The Battery Pack - I-DRILL 1i-drill Manual De Instrucciones

Plug pack charger assembly

The plug pack charger is designed to operate on voltages
between 100Volts and 240Volts AC, 50 or 60Hz.
The only requirement is to fit the required pin insert into the
plug pack charger.
The plug pack charger consists of the charger housing and
4 clip on plug configurations.
WARNING
DO NOT attempt to use the
charger without fitting one of the
supplied clip on pin moldings.
DO NOT
insert the clip on
moldings into ANY general
power outlet without FIRST
attaching to the charger plug
pack housing.
Select the pin configuration
attachment to suit the general
power outlet to be used.
Orientate the pin attachment so
the rear of the molding aligns
with the recess in the plug pack
housing. The attachment will
only assemble one way. When
aligned, insert the pin attachment
fully and the insert "Clicks" into
place. CHECK the insert is
locked in place.
To remove the pin attachment
insert, press and slide down the
small release button and pull
the insert from the plug pack
charger.
Fitting and removing
the battery pack
To remove the battery pack from
the drill, press the two side tabs
on the battery pack firmly and
pull the pack from the drill.
To fit the battery pack into the
drill, orientate the battery pack so
the side tabs of the battery pack
are on the left and right side of
the drill, and the high trim section
of the pack is forward. Enter the
pack into the drill aligning the ribs
of the pack with the inner ribs of
the drill. Push the battery pack
all the way into the drill handle
without forcing. The side tabs will
"Click" into place preventing the
pack falling out.
To fit the battery pack into the
charger, Orientate the battery
so the side tabs of the battery
are to the sides of the charger
and the high side of the battery
trim is towards the charger base
indicators. Align the ribs of the
battery pack with the ribs of the
charger base recess and insert
the battery all the way into the
charger. The side tabs are not
used.
To remove the battery pack from
the charger base, lift the battery
from the charger base without
the need to depress the battery
pack tabs.
13
GB