Battery Charging; Operation; Intended Use - I-DRILL 1i-drill Manual De Instrucciones

Battery charging

IMPORTANT. Before attempting to charge the battery,
check the charger, the charger base and the battery
to ensure the charging equipment matches the battery
supplied. The components are all labelled with
component numbers.
CAUTION! The rechargeable battery is not fully charged on
leaving the factory. Charge the rechargeable battery before
GB
first use.
CAUTION! The working temperature of the charger is 0
degree to 45 degrees (32 degree f to 115 degree f).
CAUTION! When recharging the battery, connect the plug
pack charger into the charger base, then connect the plug
pack charger to the power source. The battery should be
inserted last.
1. Assemble the plug pack charger with the required pin
configuration. Connect the plug pack charger to the
charger base, and then plug in the plug pack charger into
the mains supply and turn on. The green LED will display.
2. Insert the rechargeable battery into the charger base (6).
The red LED will light and the same time the green one
will turn off.
3. The charging process will last approx. 45 - 60 min and
be displayed by red permanent lighting of the LED. The
charge will be completed when the red LED goes out and
the green LED lights up.
CAUTION!
If the red or green LED keeps flashing during
the charging process for more than 20 minutes, please
remove the battery and allow to cool down for 15 - 30
minutes. Then insert it into charger base again, if the LED
still flashes, the battery and charger require service.
Note. If the battery pack is still hot to hold, allow to cool for a
30 min and re insert. The charger will not charge a hot battery.

Operation

Intended use

This drill is mainly used for drilling in wood or metal sheet
and screwdriving. Use the tool and accessories only for
intended applications. The machine is intended only for use
in household. All other applications are expressly ruled out.
Inserting and removing bits
WARNING:
Before any work on the tool (e.g. maintenance,
tool change etc) as well as during transport and storage,
set the rotational direction switch to the centre position.
Unintentional actuation of the On/Off switch can lead to injuries.
This drill has a keyless chuck,
which means that a chuck key
is not needed to secure a bit in
the drill.
Open the chuck by unscrewing
it in an anti-clockwise direction,
holding the drill as shown.
Do this sufficiently enough to
allow the drill bit to enter the jaws
of the chuck.
Ensure the drill bit is fully inserted, so that the chuck jaws
grip the straight section of the bit.
Rotate the chuck clock-wise until the jaws tighten on the drill
bit. The collar of the chuck needs to be tightened firmly to
ensure the drill bit is held securely.
To remove the drill bit, rotate sharply the chuck in a anti-
clockwise direction, sufficiently enough to allow the drill bit
to be removed.
Note. This device is fitted with spindle lock and the chuck
is a one handed operation.
14