Accessories - I-DRILL 1i-drill Manual De Instrucciones

Additional safety instructions
for the charger and batteries
a)
Use only the charger and batteries supplied in this pack.
b)
Protect the charger and battery pack against moisture
including rain and high humidity.
c)
Always check that the power cord is correctly connected
before using the charger.
d) When you are not using the charger, remove the plug
from the mains socket. Do not pull the plug out by the
power cord.
e) Handle the battery pack carefully. Do not let it fall or be
subject to impact.
f) Always remove the plug from the power socket before
you clean or maintain the charger or battery pack.
g) Do not charge the battery pack if the ambient
temperature is less than 40° Fahrenheit (4 ° C) or
greater than 104° Fahrenheit (40 ° C).
h) Do not short circuit the battery pack. A short circuit gives
rise to a heavy current causing overheating and the
possibility of fire or explosion.
i)
Do not connect a cable to the battery pack terminals.
j)
Make sure that no metal objects such as a nail, paper clip
or coin finds its way into the charging socket.
k)
A damaged battery pack or one which no longer holds
its charge must be disposed of in a special way and not
placed for normal household rubbish collection.
l) Never throw a battery pack into a fire or into water.
Wear goggles
Wear earmuffs
Wear a breathing mask

Accessories

We recommend that you purchase your accessories from
the same store that sold you the tool. Use good quality
accessories and the brand recommended by the vendor.
Sales staff will assist you and offer advice.
6. Safety instructions relating specifically
to the equipment (all locations)
CAUTION! LED is laser class 1! Do not look
directly into the laser as this may result in damage to
the eyes.
• Use the appliance, the charger and the attachments, only
for their intended applications!
• Before laying the stick drill/driver aside, ensure that all
moving parts have come to a standstill.
• Avoid frequent blocking when drilling, tightening or
loosening screws.
• Connect the charger only to a 100V - 240V power supply
using the provided clip on adaptor pins for the local area.
Do Not modify the pin adaptors or the charger plug pack
in any way.
• Charge the drill/driver battery only with the charger
supplied.
• Protect the charger and the drill/driver from contact with
moisture. Never immerse in water!
• Do not use the charger in the open air.
• To avoid damage to the batteries, never expose them to
temperatures of over 50 °C.
CAUTION! Do not short-circuit the contacts of the
battery or charger.
• When charging, ensure that the device is correctly
connected („+/–").
• Do not attempt to burn the battery.
• The connection cord cannot be replaced. In case of
damage, dispose of the device in the correct manner.
In case of damage, dispose of the device in the correct
manner.
9
GB