Temperature Units - yellow jacket 52070F Instrucciones De Operación

TEMPERATURE UNITS

1. Press OK Button to open the Settings
2. Press OK Button to select this option.
3. Use the RIGHT/MENU Button to toggle
MEASURE MENU
Press OK Button to enter the Measure menu two selections are available:
Temp.Max and Temp.Min, Press OK Button to set current select item on or off.
• Screening Mode: Set the Screening Mode to ON when using the thermal
imager for Elevated Skin Temperature Screening. When using the thermal
imager for any other application, Screening Mode should be set to OFF.
• Alarm Temperature: When the thermal imager is being used for Elevated
Skin Temperature Screening, a buzzer alarm will sound if the Alarm
Temperature is exceeded.
• Temperature Compensation: In screening mode, the surface
temperature will be compensated.
• Center Spot: This option enables the thermal imager to detect the
temperature of the center spot.
Menu
The color of option value will change
to black °C.
°C, °F and k, use ESC/OK Button to exit
focus state and the color of option value
will change to black k.
• Temp. Max: This option enables thermal
• Temp. Min: This option enables thermal
EMISSIVITY
Emissivity is a number which describes a materials ability to emit thermal
radiation. It is a number between 0.1 and 1. A number like 0.1 represents
a perfect reflector (like aluminum foil) whereas the number 1 represents a
perfect emitter (like black cloth). You can adjust the emissivity setting of
the thermal imager to match the material being measured. Using an emis-
sivity setting that matches the material you are measuring will ensure that
your temperature measurements are as accurate as possible. For example,
if you're monitoring the temperature of concrete as it cures, you would set
emissivity to 0.94 (see chart below) so your measurement is as accurate as
possible.
imager automatically detect the highest
temperature point.
imager automatically detect the lowest
temperature point.