UltraCOOL CP70 Guía De Uso Y Cuidado página 3

Install Casters
This unit comes with 4 stem casters: 2 locking
and 2 non-locking.
4. With the base still detached, install one caster into
each corner hole of the base. The stem should fit
snugly into hole.
NOTE Install both locking casters on the same side
(front or back) to ensure equal and secure locking
Attach Body and Base
5. To attach the base to the body, turn the unit on its side. Line up the connect
points on the pedestal and the base of the unit.
6. Use the four screws provided to attach the base to the body of unit. Set upright.
Fill with Water
The reservoir on this unit holds 6 gallons.
1. To fill the reservoir, open the water fill door
at the front and fill with fresh, clean water
using a fill hose or pitcher. DO NOT
OVERFILL.
CAUTION: If moving the unit for filling, make
sure the casters are unlocked for easy mobility.
Do not tip unit.
2. A fill indicator to the left of the fill door
shows the water level. When the reservoir is
full, the window will show a full blue fill. As
the water level decreases, the blue fill level
will lower in the window. Observe this fill indicator to monitor the water level.
.
Fill Indicator
Fill door
3