Clearing Jams; Maintenance; Anti-Dust Cap; Lubrication - Estwing EFL50Q Manual Del Usuario

Operation (Continued)
WARNING: An improperly functioning tool must
not be used. Do not actuate the tool unless the
tool is placed firmly against the work piece.
Figure 13
Hand grip (J)
Hammer cap (K)
NOTE: Make sure the hammer cap on the flooring
nailer is in the up position before adding the air hose,
if not, the nailer may cycle (See below):
Hammer Cap (Up Position) Hammer Cap (Down Position)
7

Clearing jams

Occasionally, fasteners may become jammed in the firing
mechanism of the tool, making the tool inoperable. To
remove a jammed fastener, follow the steps below:
1. Disconnect the tool from air source.
2. Empty the magazine. Make sure all fasteners are
removed.
3. Try to fire the tool into a piece of scrap wood or
flooring to make sure that it's incapable of firing any
fasteners.
4. Pull up on the latch (F) and open the jam release (G).
(See figure 14 & 15)
Remove the jammed fastener, using plier or a
5.
screwdriver if required.
6. Close the jam release (G) and latch (F). (See figure 16)
7. Reload the tool with fasteners, then reconnect the air
source to the tool.
8. Press the drive guide (H) against a piece of wood, and
test fire the fasteners several times to check for
proper operation. If the tool is properly firing, you may
continue using the tool. If the tool fails to perform
properly, immediately discontinue use and have the
tool repaired by a qualified service technician.
WARNING: Make sure there is no fastener in the
magazine before clearing a jam.
Figure 14
Latch
Figure 15
Jam Release
Driver Guide
(H)
12
Figure 16
(F)
WARNING:
and cleaning are done:
1) Disconnect the tool from the air source.
2)
Empty the magazine completely.

Anti-dust cap

Each tool is packed with an anti-dust cap on the air
connector, check it after unpacking.
Keep the anti-dust cap to cover the air connector when
the tool is not in use.
(G)

Lubrication

Frequent, but not excessive, lubrication is required for
best performance. Oil for the tool added through the air
line connection add will lubricate the internal parts. Do
not detergent oil or additives as these lubricants will
cause accelerated wear to the seals and bumpers in the
tool, resulting in poor tool performance and frequent tool

maintenance.

Operation (Continued)
Maintenance
1.
Disconnect the air supply from the tool to add
Any time inspection, maintenance,
lubricant.
13 WWW.PR IME G LO BALPRO DU CTS.C O M
Please contact 1-888-669-5672 for further assistance.