Polishing; Application; Stopping Operation; Transporting The Unit - Kärcher Tornado BR 400 Instrucciones De Servicio

BR 400

Polishing

Application

Stopping operation

Transporting the unit

10
• Polishing is carried out without water and without vacuuming. If
required the tanks can be removed, facilitating polishing under
furniture, etc.
Caution:
To avoid damaging the floor due to overheating, do not allow the unit
to run in one place.
If necessary, reduce the brush pressure.
Note: The unit is constructed symmetrically, having vacuum bars at the
front and rear. It therefore works equally well in either direction.
• Loose coarse dirt particles must be removed by sweeping before
using the floor cleaning unit.
• The amount of water should always correspond to the floor covering
and degree of dirt.
• Select the correct brushes (see Accessories).
• The brushes are offset, enabling the unit to operate up to edges on
the left and right.
• The vacuum lips are fitted at the front and back enabling the unit to
operate in a forward or reverse direction.
• Release switch lever and spray button.
• Latch the push handle into the vertical position.
• Lift the vacuum bars using the foot key.
• Engage in the transport position using the side switch.
• Disconnect the mains cable.
• Remove, empty and clean both tanks.
• On completion of work, pressure must always be removed from the
brush rollers: either the handle must be in the vertical centre position,
or the running gear (transport rollers) must be locked in the extended
position when the handle is folded down.
• If the unit is not used for a prolonged period, rinse thoroughly with
fresh water to prevent the pump from malfunctioning.
Caution:
The transport position can only be selected when the push handle is
in a vertical position.
Position the push handle vertically when turning off the unit in order to
avoid damaging the brushes.
• The floor cleaning unit is equipped with four, small-diameter transport
wheels. Movement is no problem indoors or on even surfaces.
• Use care when on outdoor surfaces such as rough asphalt, cobbles-
tones, etc.
English