UFESA PA7000 Manual De Instrucciones página 17

base for accessories. Wait until
the blades completely stop.
●
Do not use a mixing cup if an
overlay of the cover is not placed.
●
Do not insert your hands into the
jug, even when it was taken down
for cleaning, because the blades
are still dangerous - they are very
sharp.
●
Do not insert hard objects (like
a spoon, scoop, spatula etc.) into
the jug when you connect the
appliance to power.
●
Do not wash blades immediately
using your hand. To clean the
blades use a brush attached as
the equipment.
Food processor (blender)
●
Do not touch equipment in
motion with your hands, especially
dangerous are double-sided disc
and a blade of food processor.
They are very sharp! Rough
handling can lead to injury.
●
Be careful when handling cutting
blades, when you empty the
container and during cleaning.
●
Do not wash food processor blade
and double-sided disc directly using
your hand, for washing use a brush
which is attached as equipment.
WARNING!
Risk of property damage
●
Do not disconnect the plug from the socket by
pulling on the cord.
●
Place the motor unit near a wall socket on a flat,
stable surface so that the vent holes of the
appliance are not blocked.
●
The appliance must be plugged only to
an alternating current socket with power
corresponding to the power stated on the name
plate of the appliance.
●
Immediately stop the operation and unplug the
appliance if any liquid gets into the motor. Return
the appliance to an authorised service facility for
examination and servicing.
●
Never overload the appliance by processing
extensive amounts of products or pushing them
too hard into the feeding tube.
●
Do not expose the appliance to temperatures
exceeding 60°C.
●
Do not leave unattended the apliance connected
to the power supply.
●
Do not immerse the motor unit in water or rinse it
under running water.
●
For cleaning the case do not use abrasive detergents
such as emulsions, cleaning creams, pastes,
etc. They may remove the graphic information
symbols such as marking signs, warning signs, etc.
●
Clean the metal parts (especially the filters/
strainers with a sharp blade grinder, food
processor blade and disc) with a small brush
attached as equipment.
Juice extractor
●
Unplug the juice extractor immediately if you
notice excessive vibration or rotation decrease.
Clean the filter/strainer and its housing.
●
Stop operation and unplug the appliance from
the outlet when the product is blocked in loading
hopper or on a pulping blade.Remove the cause
of the blockage.
●
Do not use the juice extractor without the
container for leftovers.
Mixing cup / grinder
●
Do not fill the jug with boiling liquids.
●
When storing never keep the cover placed on the jug.
●
Do not fill the jug above the '900 ml' mark -
if that happens, then its contents can raise the
cover when the engine is being started.
●
Do not overfill the jug. If the liquid gets into/under
the engine system, it can be sucked into the
engine, causing it to fail.
●
When you mix, the jug should contain at least
300 ml of liquid.
●
It is recommended to use the appliance with an
integrated mixing cup / grinder in continuous
operation for not more than 30 seconds.After this
time, turn off the appliance and wait 5 minutes
before restarting, allowing the engine to cool
down.The mixing process can consist of up to five
30-second cycle times.
●
Do not operate the appliance with installed mixing
cup / grinder when it is empty, because it may
overheat the appliance.
●
The temperature of the ingredients used for
mixing should not exceed 60°C.