UFESA PA7000 Manual De Instrucciones página 25

PROBLEM
The strainer is blocked.
The feeding tube touches
the strainer / The
appliance vibrates.
Preparing the appliance for
operation with accessories
1
Set the drive unit on a dry, stable and leveled surface
near an electrical outlet and away from children.
Route the power cord so that it is not
hanging down from the table or counter
and could not be accidentally pulled or
hooked.
2
Put the base for accessories on the drive unit, so
that the symbol you may see on the side of the
base is aligned with the symbol
the drive unit.
3
Lock the base for accessories by turning it
clockwise to clockwise, so the sign
the drive unit coincides with the symbol
of (the characteristic "click" indicates that the base is
properly installed).
4
Plug the power cord into a wall outlet.
Before plugging in the appliance, make
sure the control knob is set to "0".
MIXING CUP (LIQUIDISER)
Characteristics of the device
Mixing cup is designed for chopping and mixing all
kinds of products.It can be used to prepare soups,
sauces and smoothies, you can also mix vegetables,
fruits and meat, and mill (or pound) cooked ingredients
into food for the infants.
CAUSE
The product is not
suitable.
The appliance is
overloaded.
The strainer is not fitted
correctly.
D
you may see on
you may see on
on the basis
SOLUTION – WHAT TO DO
The appliance cannot be used with fruit or vegetables
that are especially hard or contain long fibres.
Switch off and unplug the appliance. Wait until the
appliance stops. Clean the feeding tube, strainer, lid
and pulp container.
Switch off and unplug the appliance. Check if the
strainer sits correctly on the skimmer. Check if the
strainer is not damaged. If the strained is damaged,
you must repair the appliance at an authorised
service centre.
Preparing the appliance for operation
Before the first use of a mounted mixing cup / liquidizer
(or after its storage for a longer period of time), clean
the jug, cover and the cap of the cover in warm water
with detergent, rinse well and dry all these parts.
Keep your hands away from blades -
they are sharp.
Maintenance and operation
1
Mount the mixing cup on the base for accessories,
so that the jug handle is placed on the right side of the
appliance.
2
Lock the jug by turning it clockwise until it locks
(the characteristic "click" indicates that the jug is
correctly installed).
The jug handle should be placed on the
right side of the appliance.
3
Put the ingredients into the jug. Do not fill beyond
the '900 ml' mark you may see on the jug.
You can load the ingredients into the jug
of blender in any way, but you have to
know that better results are obtained by
adding the hard components at first.
4
Put the cover on the jug so that the side of cover
on which the strainers of the cover are not placed, is
located at the spout of the jug. The cover installed in
this way prevents splashing of the components during
the mixing process.
E