UFESA PA7000 Manual De Instrucciones página 26

The cover of jug can be installed in three
positions, but only one position of the
cover is used in the process of mixing.
The remaining two positions are used when
transferring the mixed contents of the jug into
the utensils.
5
Insert the cover' s cap into the hole in the cover so
that the noses on the overlay are placed in the notches
of the cover. Lock the cap by turning it clockwise to
clockwise until it locks.
Do not operate the appliance with
installed mixing cup (liquidizer) without
overlay of the cover, especially if you mix
the solid components. They can be thrown
through the hole.
6
Turn on the mixing by turning the control knob to
the desired position.
If you mix at speed #2, you may achieve
better results.
Do not use the appliance with installed
mixing cup (liquidizer) in continuous
operation for more than 30 seconds.
After this time, turn it off and wait 5 minutes
before restarting, allowing the engine to cool down.
7
During mixing, you can add products (spices or
ingredients) through the hole after removing the cover
plate.
8
To stop the appliance, turn the speed control knob
to "0".
If the consistency of mixed products
does not meet your expectations, turn
the control knob to "PULSE" and hold it
in this position for several seconds; the appliance
will start its operation at maximum speed. When
the knob is released, the appliance stops.
Ice crushing
Device with installed mixing cup (liquidizer) can also
be used to crush ice cubes, you get small pieces of ice
about the same size.
Before using the mixing cup to crush ice
cubes, make sure it is clean. Otherwise,
wash it thoroughly with clean water. Any
detergent residue can affect the taste of
crushed ice and cause loss of taste of the drink,
to which it will be added.
Put into a jug no more than 15 ice cubes (about the
size of not more than 2 cm).In addition to ice cubes
pour approximately 15 ml (1 tsp) fresh cold water more.
Put the jug cover along with the overlay, then turn the
control knob to position "1". The appliance starts its
operation, and you have to crush ice every 3 seconds,
repeat it the action until the ice is completely crushed.
If the consistency of ice does not correspond to your
expectations (i.e. you want to get the consistency of
snow), turn the control knob to "PULSE" and hold it
in this position for several seconds, the appliance will
start operation at maximum speed. When the knob is
released, the appliance stops.
Do not crush ice cubes without adding
water to the jug.
After working with the mixing cup
(liquidizer)
● Turn the appliance off and remove the connection
plug from the wall outlet.
● Remove the mixing cup, to do this hold the base for
accessories with one hand, and using other hand grab
the jug handle.
● Turn the jug in a counter-clockwise direction until
it reaches the end stop and remove the jug from the
base for accessories.
● Pour the cocktail you made into dishes.
The jug cover can be installed in three
positions, but only one position of the
cover is used in the process of mixing.
The other two positions (wide strainer, narrow
strainer) are used when transferring the mixed
contents of the jug into the dishes.
● Wash your mixing cup (see section "Cleaning and
maintenance of appliance with installed mixing cup
(liquidizer) / grinder").
Removal of cutting set
● Disconnect the plug from the wall outlet.
● Turn the cover counter-clockwise until it reaches the
end stop and remove the cover from the jug.
F