Environmental Protection - Evolution R15VAC Instrucciones Originales

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

FILTER REPLACEMENT

WARNING: To reduce the risk of injury from

accidental starting, unplug power cord before

changing or cleaning filter. Your filter should

be cleaned often to maintain peak vacuum

performance.

NOTE: To avoid damage to the blower wheel

and motor, always reinstall the reusable dry

filter before using the vacuum for dry pickups

and always reinstall the foam filter before using

the vacuum for wet pickups.

NOTE: After cleaning, check the filter for

tears or small holes. Do not use a filter with

holes or tears in it. Even a small hole can cause

dust to come out of your vacuum. Replace it

immediately.

NOTE: Before installing the filter on the

vacuum, clean the area of the lid so that the

clamp ring will seal the bag against the lid and

stop small particles from bypassing the filter

bag. If the filter is clean and not damaged,

replace it on the filter cage. If it cannot be

reused, place a new filter over the filter cage.

NOTE: Clean the filter in an open area.

WARNING: Do not remove filter cage and float.

The float prevents water from entering the

impeller and damaging the motor. The cage

prevents fingers from touching the moving

impeller.

MAINTENANCE

WARNING: Any maintenance must be carried

out with the machine switched off and

disconnected from the mains power supply.

CLEANING

To keep your wet/dry vacuum looking its best,

clean the outside with a cloth dampened with

warm water and mild soap. To clean the tank:

•

Dump out debris.

•

Wash tank thoroughly with warm water

and mild soap.

•

Wipe out with dry cloth.

www.evolutionpowertools.com

STORAGE

Before storing your vacuum, the dust tank

should be emptied and cleaned. The cord

should be wrapped and hung on the unit and

the accessories should be kept in the accessory

holder so they can be readily available. The

vacuum should be stored indoors.