End Of Operation; Precautions - Omnitronic CDP-744 Manual Del Usuario

Memorizing the Loop Out-point
The Loop Out-point can be memorized in the Pause-mode and in the Playback-mode, respectively.
A sequence can be memorized after you memorized the Loop In-point. Please select the end-point (Loop
Out-point) with the Jog-dial (Pause-mode) or directly during playback (OUT/EXIT-LED illuminated). By
pushing the joystick upwards, you can memorize the current position (OUT/EXIT-LED flashes).
The memorized sequence is repeated (OUT/EXIT-LED flashes) until you push the joystick upwards once
more.

6.10 End of operation

Before you switch off the device, please make sure that no CD remains in the player.
Also make sure that the CD-tray is completely closed before you switch off. If this is not the case, switch the
device on again and close the tray with the Open/Close-button.

7. PRECAUTIONS

This CD-player cannot be compared to conventional Hifi CD-players - even if they have almost the same
appearance. This player is much more rugged in order to withstand the strenous road use and consistent
transports of mobile discotheques. We recommend to put the CD-player on plastic foam or on rubber feet in
order to avoid skipping, which is caused by vibrations of low frequencies. The same thing holds true if the
CD-player is mounted in a rack an the rack is exposed to such frequencies.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
Is your amplifier and your mixer properly adjusted?
Have you kept to all instructions given in this manual?
PROBLEM:
No power.
Player does not start operation CD is badly positioned or dirty
No sound
Does not read properly.
Pop noise
Relay-function does not work
CAUSE:
The power-cord is not connected.
Check the mixer and amplifier
connections
The device is exposed to vibrations.
Mixer or amplifier connections
inapropriate
Crossfader is wrongly assigned or
put on one side.
26
REMEDY:
Check the power-cord and any
extension-cables.
Reposition CD with label atop or clean
with a dry and soft cloth.
Possibly exchange connections.
Place the device on a more stable
stand, rack etc..
Check cable and jack quality
Assign the Crossfader correctly and
put it in the center position.