Camera Location And Set Up; Camera Operation - Safety 1st 48018 Manual Del Propietário

Camera Location and Set Up

Note: Camera is intended and designed for indoor use only.
Position Camera in several locations and at several angles to select the best view of your baby. Once determined, test the reception of
the 900 MHz Sound & Sight Television Monitor. Camera can be positioned on a table, dresser or mounted to the wall. BEFORE installing
any wall mount screws, have one adult hold Camera in place of proposed mounting position and have another person check the
Television Monitor for reception of desired view. If interference develops, refer to Troubleshooting section on page 11 of this instruction
manual. Make sure location chosen is free from dust and moisture.
WARNING:
In selecting a location to mount the Camera, keep the following things in mind:
• To prevent entanglement, only mount the Camera in a location where it and its AC Adapter cord are OUT OF REACH
OF CHILDREN.
• For best viewing, mount the Camera approximately 6 feet (2m) away from the child.
• Mount the Camera in a location where the Camera lens will have an unobstructed view. Use the tilt and swivel adjustments
to properly aim the Camera.
• Allow adequate ventilation of the Camera when mounted on a wall. DO NOT mount the Camera directly above heating
vents, other heat-producing sources or in direct sunlight.
• Make certain that the Camera will be mounted so that the AC Adapter cord will reach an outlet. To prevent entanglement
and overheating, NEVER use an extension cord.

Camera Operation

• Make sure Camera and Receiver are set on the same channel.
• Slide ON/OFF switch to "ON" position.
• Slide Audio Only Switch to "Video On" position.
• To Adjust, turn Tilt Adjustment Knob counterclockwise just enough to loosen Camera. Move Camera up or down to desired
position and tighten Camera in place by turning Tilt Adjustment Knob clockwise. DO NOT OVER TIGHTEN. Swivel Camera
side to side for preferred angle.
IMPORTANT: CAMERA WILL TURN APPROXIMATELY 180º. DO NOT TURN PAST 180º.
CAUTION: TO PROTECT THE PRIVACY OF YOUR HOME, ALWAYS TURN CAMERA OFF WHEN NOT IN USE. DO NOT ATTEMPT TO
ADJUST THE SMALL ANTENNA ON CAMERA OR RECEIVER.
Note: Before selecting a permanent location for your camera, please read the "Testing Reception" (page 10) portion
of this manual.
WALL MOUNT OPTION:
• Using a 3/16" drill bit on an electric drill, drill pilot hole in the wall.
• Place the Wall Anchor in the drilled hole.Tap gently with a hammer on the Wall Anchor until the end of the Wall Anchor is even
or flush with the surface of the wall. See Figure B.
• Insert the screw in the Wall Anchor and tighten until there is a gap of 1/4"(6.2mm) between the wall and the Screw head.
See Figure C.
• Unwrap and fully extend AC Adapter cord.
NOTE: Use the AC Adapter that is bigger in size, but has a smaller plug.
• Plug the jack on the Camera's AC Adapter cord into the AC Adapter Jack on the bottom of the Camera.
• Hold Camera so underside of Base/Wall Mount faces you.
• Insert the AC Adapter cord into the groove on the bottom of the Base/Wall Mount as shown in Figure D. Make certain the
AC Adapter cord stays in the groove as you place Camera on wall mount Screw.
• Slide the Camera Base/Wall Mount on the Screw to secure it to the wall. See Figure E.
NOTE: If the Camera does not slip easily onto the wall mount Screw, remove Camera from the wall and slightly loosen the Screw.
• Plug AC Adapter into a standard wall outlet.
• Wrap up and secure any excess AC Adapter cord.
Page 6