Descargar Imprimir esta página

ASROCK H67M-GE Guía Rápida De Instalación página 25

Publicidad

HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The LED
is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module mainly
consists of power switch, reset switch, power LED, hard drive activity LED,
speaker and etc. When connecting your chassis front panel module to this
header, make sure the wire assignments and the pin assign-ments are
matched correctly.
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.2 No. 18)
Power LED Header
(3-pin PLED1)
(see p.2 No. 19)
Chassis and Power Fan Connectors
(3-pin CHA_FAN1)
(see p.2 No. 8)
(3-pin CHA_FAN2)
(see p.2 No. 34)
(3-pin PWR_FAN1)
(see p.2 No. 1)
CPU Fan Connectors
(4-pin CPU_FAN1)
(see p.2 No. 2)
Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin
CPU fan still can work successfully even without the fan speed control function.
If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this
motherboard, please connect it to Pin 1-3.
ASRock H67M-GE Motherboard
Please connect the chassis
speaker to this header.
Please connect the chassis
1
power LED to this header to
PLED-
PLED+
indicate system power status.
PLED+
The LED is on when the system
is operating. The LED keeps
blinking in S1 state. The LED is
off in S3/S4 state or S5 state
(power off).
Please connect the fan cables
to the fan connectors and
GND
+12V
match the black wire to the
CHA_FAN_SPEED
ground pin.
GND
+12V
CHA_FAN_SPEED
PWR_FAN_SPEED
+12V
GND
Please connect the CPU fan
FAN_SPEED_CONTROL
CPU_FAN_SPEED
cable to the connector and
+12V
GND
match the black wire to the
ground pin.
1 2 3 4
Pin 1-3 Connected
3-Pin Fan Installation
25

Publicidad

loading