Campbell Hausfeld Cl15 Serie Instrucciones De Operación página 3

14. NEVER point an air tool at oneself
or any other person. Serious injury
COULD occur.
impact quality sockets only. Hand tool
sockets are "glass-hard" and will shatter
and can cause serious personal injury if
used with air tools.
Operation
set-up InstRuctIons
Air tools require a supply of clean, dry air
at 90 PSI (6.2 bar). An air supply system
with filter, regulator, and lubricator (FRL)
as shown in Figure 1 should be used.
Campbell Hausfeld FRL model PA2104
(3/8 inch) or PA2114 (1/2 inch) is
recommended.
water in the air supply can damage the
tool. Drain condensate from compressor
tank and filter daily.
All hoses and fittings must be the correct
size and tightly fastened. Refer to Chart 1
for minimum sizes.
Figure 1
Do not use hand
tool sockets. Use
Option 1: Individual components
Filter
Option 2: 3 piece combo
Filter, Regulator, and Lubricator
www.campbellhausfeld.com
Cl15xx and Cl25xx series
Tool Air Consumption
Less than 9 SCFM @ 100% usage
9 to 34 SCFM @ 100% usage
Greater than 34 SCFM @ 100% usage
Chart 1 - Suggested minimum hose diameter to
use based on 50 ft length hose and continuous
SCFM rating of tool. The use of fittings and longer
hose may require a larger diameter hose to be
used.
that are damaged or deteriorated.
pull the hose to move the tool or a
compressor. Keep hoses away from heat,
oil and sharp edges. Replace any hose
that is damaged, weak or worn.
luBRIcatIon
Air tools require lubrication throughout
the life of the tool and is the owner's
responsibility. Failure to lubricate the air
tool properly will dramatically shorten the
life of the tool and will void the warranty.
Regulator Lubricator
Hose ID
1/4 inch
3/8 inch
1/2 inch
Do not use
hoses or fittings
Never carry a tool
by the hose or
3