VESTEL EVC04 Serie Guia De Instalacion página 46

4.8 - CHANGE STANDALONE MODE SETTINGS OF THE DEVICE
If you have set OCPP as enabled in OCPP settings before, standalone mode cannot be selected.
The mode list and "Save" button will be disabled in this situation.
Otherwise, you can select standalone mode from the list. There are three modes in the list;
Select "RFID Local List" mode to authenticate a RFID local list which will be entered by you. You
can make an addition or deletion from the RFID local list later.
Select "Accept All RFID's" mode to authenticate all RFID's.
Select "Autostart" mode to allow charging without the need for authorization. It will be enough to
plug to start charging.
Select "Smart" mode to activate smart mode.
If you are done with mode selection, click "Save" button.
IG v7.3.0 2020
Figure.44
Figure.45
© 2020 Vestel - All rights reserved English - 45