Maintenance
3. Pull front edge of plastic
ember bed or plastic grate
up and forward until rear
tab releases from the ledge
located at the bottom of
the partially reflective glass
(Figure 3).
!
NOTE: Log set fits tightly into
firebox, some force may be
necessary to remove.
4. Set logset in front of firebox.
5. Disconnect the logset LED
wire harness from unit
(Figure 4).
6. Examine the bulbs to
determine which bulbs require
replacement.
7. Unscrew bulbs counter
clockwise.
8. Insert new bulbs.
9. Re-connect the logset LED
wire harness to the unit.
10. Replace the log by inserting
the rear tab of the logset
under the back ledge of the
fireplace and push down on
the front edge of the logset
until it snaps into place
(Figure 3).
11. Replace log grate using two
screws previously removed.
Figure 3
Back
Ledge
Rear
Side Section
Tab
Figure 4
Log
Ember
bed
Front
Edge
LED Wire
Harness
9