Flush Mounted Installation - 2X8 Framing - Empire EBL50 El Manual Del Propietario

Fireplace Installation
1. Refer to Front Glass Installation
section for final installation
procedures.
Figure 10
Mounting
holes
Figure 11
14
2 x 8 Framing
Flush Mounted
Installation - 2x8 Framing
CAUTION: Two people may be
required for various steps of this
procedure.
1. Prepare a wall with a framed
opening of 49 in. (124.5 cm) wide
x 18½ in. (47 cm) high (Figure 11).
!
NOTE: The sizing has allowed for
1/4" (6.4 mm) around the fireplace
insert for ease of installation. This
fireplace does not require any
additional venting.
2. Choose your method of supplying
power to the unit:
• Plug-in (you may run the power
cord out of the framed wall
opening to an existing outlet or
install an outlet on a nearby wall
stud within the wall).
• Hardwire the fireplace - follow the
hardwiring instructions on page 9.
WARNING: Do not attempt to wire
your own new outlets or circuits.
To reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
WARNING: Ensure that the circuit
on which the fireplace is to be
installed has the power cut off at
the service panel until installation
is complete.
www.empirecomfort.com