Sleep Timer - Empire EBL50 El Manual Del Propietario

Operation
on the unit at the same time and
holding for 2 seconds will disable
and enable the heater.
! NOTE: When the heater has
been disabled and either the
or the
On Screen Display will indicate
"--".
F. Color Themes
Different presets of ambient
lighting color combinations
contained in the unit.
→ Changed by repeatedly
pressing the corresponding
button on the remote or the
unit.
• Cycles through the different
preset ambient lighting settings
of the unit, this includes
different combinations of
colours of the flame base and
media lighting.
! NOTE: The last theme of the
cycle is a prism where the
unit cycles through a variety
of colours. Pressing the
button stops the cycling and
holds the unit on the preferred
color, indicated by a "U" -
Unfreeze or a "F" - Freeze on
the display.
is pressed the
G. Brightness
Changes the brightness of the
lights in the unit.
→ Adjusted by repeatedly
pressing the corresponding
button on the remote.
• Indicated by the second digit
on the Floating Display™
changing to show: "H" (high),
and "L" (low).
H.

Sleep Timer

The Sleep Timer can be set to
automatically shut off the fireplace
after a preset time (from 30
minutes to 8 hours).
→ To set the timer press the timer
button on either the remote or
the unit, repeatedly, until the
desired time is displayed.
• The On Screen Display will
display the different times as it
is adjusted. Once the timer has
begun, pressing the
will display the time remaining
before the unit turns Off.
! NOTE: The Sleep Timer can
be cancelled at any time
by pressing the
repeatedly until the sleep timer
displays nothing.
button
button
19