• Lightly touch the shutter release to trigger the
exchange of data between the flash and the
camera.
mecablitz 45 CL-4 digital
• Set the flash device to TTL or manual flash mode
(see operating instructions of the flash device).
• Press the "mode" button until "HSS" appears in
the display
4.10 Wake-up function for the flash unit
The 44 MZ-... and 54 MZ-... flash units feature
an auto-off function that automatically switches
the units off 1, 3 or 10 minutes after the last flash
was fired or a setting was made. The flash unit is
then in a power saving standby state. As soon as
the camera's shutter release is touched the SCA
adapter will wake up the flash unit and switch it
on again (wake-up function).
To avoid discharge of the power sources
remember to switch off the flash unit by its
main switch if you are not going to use it for
an extended period of time.
5. Cordless Metz Remote Flash Mode
In the Cordless Metz Remote Mode a master flash
unit ("controller") mounted on the camera controls
the light output of one or more slaves. For system-
induced reasons the master flash unit must work
in the auto flash mode (Metz Auto Remote Mode).
The Metz TTL Remote Mode is not supported
due to the pre-flash metering system of Olym-
pus digital cameras! If the master ("controller")
function is activated in TTL flash mode on the
flash unit, then the display
28
of the SCA adap-