COMFORT-AIRE RG Serie El Manual Del Propietario página 16

INSTALLATION INSTRUCTIONS
Step 3. Slide the R1 insulation panel into the
Step 3. Slide the R1 insulation panel into the side
side curtain, the side with pattern should face the
curtain, the side with pattern should fac• • the indoor••
side.(Fig.13).
indoor side. (Fig.13).
Fig.13
Step 4. Repeat on the other side.
INSTALL WEATHER STRIPPING (only
7
applicable to Energy star models)
In order to minimize air leaks between the room air
In order to minimize air leaks between the room air••
conditioner and the window opening, trim the weather
condit•• o ner and the window opening, trim the
stripping to a proper length, peel off the protective
weather st•• i pping •• •••• a proper length, peel off the
backing and plug any gaps if needed (Fig. 14). protective backing and plug any gaps if needed
(Fig.14).
Fig.14
14
Owner's Manual - RG/RADS Series
If AC is Blocked by Storm Window
Add wood as shown in Fig.15, or remove storm
window before air conditioner is installed.
If Storm Window Frame must remain, be sure the
drain holes or slots are not caulked or painted shut.
Accumulated Rain Water or Condensation must be
allowed to drain out.
Removing AC From Window
Turn AC off, and disconnect power cord.
Remove sash seal from between windows, and
unscrew safety sash lock.
Remove screws installed through frame and frame-
lock.
Remove the R1 Panel and close (slide) side panels
into frame.
Keeping a firm grip on air conditioner, raise sash
and carefully remove.
Be carefully not to spill any remaining water while
lifting unit from window. Store parts WITH air
conditioner.
Storm window
1-1/2"min
frame or other
obstruction.
SASH
Board
thickness
(38 mm)
as required,
for proper
pitch to rear,
along entire
sill. Fasten
with nails or
screws.
Fig.15