Tabla de contenido
Publicidad
CU ACTIVE ERRORS (Control Unit Active Errors) [ro]
CU Active Errors
Bit 7
Bit 6
Bit 0
Internal error: data corruption
Bit 1
Internal error: bus fault
Bit 2
Primary voltage too low
Bit 3
Primary voltage too high
Bit 4
Secondary voltage too low
Bit 5
Secondary voltage too high
Bit 6
Supply pressure too high (< 1,9 bar) or too low (> 6,3 bar)
Bit 7
Error in one or more ejectors
CU CONDITION MONITORING
(Control Unit Condition Monitoring)
res
Bit 7
Bit 6
Bit 0:3
CU Condition
Monitoring
Bit 4:7
EJECTOR (1-16) STATUS [ro]
(Ejector 1 - 16)
CM ejector
Bit 7
Bit 6
Bit 0:1
Estado
Bit 2:7
CM ejector
ES · 30.30.01.02237 · 00 · 04/20
10 [orange] Device is working, but there are warnings in the Control-
Unit
11 [red] Device is not working properly, there are errors in the Control-
Unit
Bit 5
Bit 4
Bit 5
Bit 4
Condition Monitoring of Control Unit
Bit 0 = Primary Voltage limit
Bit 1 = Secondary voltage limit
Bit 2 = Input pressure limit (3,5 ... 5bar) (hysteresis = 0,2 bar)
Bit 3 = Warning in one or more ejectors
res:
reserved
Bit 5
Bit 4
Bit 0: H1 level reached (air saving function) in Ejector
Bit 1: H2 level reached (part present) in Ejector
Conditon Monitoring of ejectors
Bit 2 = Valve protection active
Bit 3 = Evacuation time greater than limit
Bit 4 = Leakage rate greater than limit
Bit 5 = H1 not reached in suction cycle
Bit 6 = Free flow vacuum too high
Bit 7 = Manual Mode Active
Bit 3
Bit 2
CU Condition Monitoring
Bit 3
Bit 2
Bit 3
Bit 2
Interfaces
Bit 1
Bit 0
Bit 1
Bit 0
Estado
Bit 1
Bit 0
33 / 98
Publicidad
Tabla de contenido
