Sharp MD-MT180H Manual De Manejo página 163

Master MiniDisc operation
1
Insert a master MiniDisc.
Do not mistake the master MiniDisc for the target one.
2
Whilst in the stop mode, press the MENU/CHRG but-
ton repeatedly to select "EDIT".
3
Press the ENTER/SYNC button.
4
Press the MENU/CHRG button repeatedly to select
"NAME STAMP".
5
Press the ENTER/SYNC button.
To cancel the operation, press the :OFF/HOLD button.
6
Press the ENTER/SYNC button.
7
When the unit displays "CHANGE MD", remove the
master MiniDisc.
Remove it without turning off the power. Or, the operation
will be cancelled.
Operation of the MiniDisc for stamping
8
Load a MiniDisc for stamping.
9
Press the ENTER/SYNC button.
The unit will finish recording the character information
and enter the stop mode.
Note:
If the total number of tracks on the master MiniDisc does
not match that on the MiniDisc for stamping, the unit will
display "Can'tSTAMP" and turn off the power.
If this happens, adjust the total number of tracks on the
newly recorded MiniDisc using the edit operation.
01/10/11 180H_E_5.fm
MD-MT180H
ENGLISH
E-30