Troy-Bilt FLEX 23AABA6X711 Manual Del Usuario página 9

Discharge Chute
The position of the upper discharge chute can be adjusted to
control the distance that the discharged snow will be thrown,
and the direction at which it will be discharged. Follow these
steps to adjust the discharge chute:
1. Loosen the wing knob on the upper chute, adjust the chute
to desired operating position.
2. Tighten the wing knob on the upper chute making sure
the carriage bolt on the inside of the discharge chute is
correctly positioned. Refer to Figure 3-8.
Figure 3-8
3. To adjust the direction that the snow will be thrown, use
the handle on the upper discharge chute to control the
direction of the discharged snow. Refer back to Figure 3-8.
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with this snow thrower attachment. See Figure 3-9.
Store them in a safe place until needed.
Figure 3-9
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Figure 3-10.
Chute Clean-out Tool
Figure 3-10
S
ection
3 — A & S -U
SSembly et p
9