Adding A Remote Control Without Accessing The Motor Head; Troubleshooting; Digital Display; Power Outage - SOMFY Dexxo Pro 800 RTS Manual De Utilización

Detection of forced entry operation
Detection of forced entry starts operating 30 seconds after the door is closed.
siren, press a button on a memorised remote control.

Adding a remote control without accessing the motor head

With a Keygo (Fig.12a)
A
A

TROUBLESHOOTING

Digital display

The LCD display is situated under the lighting cover. It provides motor operation status.
The main operating codes are as follows:
Code Description
C1 Waiting for a command
C2 Door opening
C3 Waiting for the door to close
C4 Door closing
C5 Obstacle detection
C6 Safety input active
C9 Pedestrian door safety contact active
Cb Permanent hardwired control
CC Maintenance is required
Cd Working from back-up battery
Waiting for a command
H1 Detection of forced entry
H2 Detection of forced entry
If other codes are displayed, contact your Somfy installer.

Power outage

Following a power outage, the motor must recognise its «fully open» position again.
Open the door fully using a memorised remote control. The door will open at a degraded speed.
Allow the door to open to the "fully open" position.
12a
2s
B
Comments
Indicates that the door encountered an obstacle. The display is maintained for 30 s after detection.
Indicates that an obstacle preventing door closure is present between the photoelectric cells or is in contact with
the safety sensor bar installed on the door.
Indicates that the pedestrian door within the garage door is open. Door operation is inhibited.
Indicates that the hardwired control input is permanently active. Commands from radio remote control units
are inhibited.
Indicates that maintenance is required on the installation. Contact your installer.
Indicates that the main power supply to the motor is cut and that the motoris powered by the battery back-
up pack.
Indicates that an attempt to open the garage door has been made from outside.
Press a button on the memorised remote control to stop the siren.
Start a complete opening and closing cycle.
Indicates that an attempt to open the garage door has been made from outside.
Press a button on the memorised remote control to stop the siren.
Start a complete opening and closing cycle.
With a Telis or similar (Fig.12b)
12b
A B
2s < 1s
5