Rowenta ULTRA STEAM Instructivo De Operación página 10

1800128848 DR6015 U1_110 x 154 02/05/13 09:42 Page4
Lint pad
The lint pad can not be used
when attached to appliance.
Threads, lint and hair can easily be
removed with the lint pad by brushing
the clothes slowly from left to right.
The pad can be cleaned by brushing
in the opposite direction right to left
on a piece of old cloth.
• Remove the lint pad from the
steam brush by pulling it to the
bottom - fig.10a.
• For storage, attach the lint pad to
the steam brush. Gently push the
top of the lint pad into place until it
snaps in - fig.10b.
fter use
Wait for 15 minutes until the
steam head is completely cool.
• Unplug the appliance. Empty the
water remaining in the tank and
leave unit on its side to cool.
fter the appliance has cooled
down, it may be stored thanks to
the hanger hook.
Warning: never forget to unplug
the steam brush and empty the
tank after your working session.
While not in use, you can hang
your steambrush by its hook.
Cleaning/Descaling
• Clean the main unit with a damp
cloth.
• Your steam
descaled occasionally
notice the steam power is weak.
brush must be
if you
The time between
operations depends on the quality
of the water and the frequency
with which you use the appliance.
• To carry out an effective descaling
operation, we advise you to :
1. Fill the water tank with white
vinegar.
2. Plug the appliance and wait until
it reaches
temperature.
3. bove a sink, press the steam
trigger. Wait for a few seconds.
Press again the steam trigger.
4. Repeat the previous steps until
the water tank is empty. The scale
will be removed. Stay away from
the steam output: there is a risk of
particles spitting.
5. Important: It is necessary to clean
the appliance to avoid spattering
your clothes with vinegar residue.
It is important to clean the water
tank with water, then, to fill it
again with fresh water.
6. Repeat steps 3 and 4 until the
water tank is completely empty.
7. Unplug the steam brush. Wait 15
minutes until it is completely
cool. Use a rag to wipe the scale
marks that may appear on the
steam head during descaling
operation.
C UTION: Risk of electric
shock. Never immerse the
steam head in water! The
steam brush contains electric
components that could be
damaged by direct water.
4
descaling
the working