Rowenta ULTRA STEAM Instructivo De Operación página 9

Ocultar thumbs Ver también para ULTRA STEAM:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1800128848 DR6015 U1_110 x 154 02/05/13 09:42 Page3
• Remove the water tank by pulling
it backwards -
• Remove the stopper.
• Fill the watertank to the M X level
with water -
securly. Make sure that the stopper
is properly pushed in place - fig.5.
• Put the tank into the handle until it
snaps in - fig.6.
• Completely unwind the power
cord. Plug in your steam brush -
fig.7.
USE
During use or while unit is
heating or cooling, do not rest
appliance on its head. Place
product on its side on a stable,
heat resistant, flat surface, as
the head will be hot. s the
appliance heats, the housing
becomes warm. This is normal.
• Once the appliance is plugged in,
the light is on - fig.8.
fter approximately 50 seconds,
and when the light is off, it has
reached working temperature.
• To begin steaming, press by
successive pressures the steam
trigger with the steam brush facing
away from you, holding it in
vertical position - fig.9.
Steaming clothes
Before removing or attaching
the fabric brush, unplug your
appliance and let it cool down.
The Ultra Steam is equipped with a
fabric brush.
fig.
3.
fig.4
and close it
• To attach the accessory, line it up
with the steam head. It locks into
position with an audible click -
fig.2/fig.11a.
• Simply pull on the top of the fabric
brush to remove it - fig.11b. You
can operate the unit with or
without the accessory.
• Hang
the
creased
clothing on a clothes hanger
• Pull the clothing tight with one
hand. Your hand must be far
enough from the steam brush to
avoid burning it with the steam
output. Place the appliance over
the creased area, beginning at the
top of the garment.
s steam is very hot: never
attempt to remove creases
from a garment while it is
being worn, always hang
garments on a clothes hanger.
lways keep your hand far
from the steam output.
• Gently press the fabric brush
against the clothing and move the
steam brush down the fabric. Press
by successive pressures, every 4
seconds, the steam trigger - fig.9.
• The combination of steam and
brush will gently remove the
creases.
fter treatment, let the garment
cool down on the hanger before
wearing.
3
EN
FR
article
of
ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ultra steam dr6025u5Ultra steam dr6020u5

Tabla de contenido