pair remote
The original remote that comes in the box is already paired to the bed base.
No further action is required.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote control.
Remove and replace batteries.
STEP 2
Double click the button on the Power
Down Box (this will not cause the base
to move). The light will illuminate.
If the Power Down Box is not available- Press Reset button on control box. Pairing LED light on control box will begin to blink. Press and
hold button on the back of the remote, the button will begin to blink. Both lights will become continuous and then simultaneously turn off.
14
STEP 3
Press and hold button on the back of the remote.
The light will begin to flash then become a
continuous solid light.
STEP 4
Both lights on the Power Down Box and the
Remote will be continuous, then simultaneously
turn off. Replace back cover of the remote.
The remote is now paired with the base.
setting up two bases
If any split setup is being installed, plastic connecting straps are provided (one per base) to
secure the bases together. Use both straps to secure the head and foot portions together.
STEP 1
With the bases in their desired location, slightly loosen both legs
to allow the strap to fit on the leg bolt, between the leg washer
and frame.
STEP 2
Slide side (a) of the connecting strap onto leg bolt. Swing the strap
and connect side (b) to the leg bolt. Secure the strap by shifting to
the left.
a
b
STEP 3
Re-tighten legs. Do not over tighten. Use the remaining strap and
repeat on other end of the base.
15