Kohler K-2453 Guia De Instalacion página 3

Measure distance
from center width
mark.
Large side
of hanger
faces wall.
Finished Wall
1. Install the Mirror
IMPORTANT! Get assistance when determining the desired
placement of the mirror. One person should hold the mirror in place
while the other measures and marks the placement.
Hold the mirror flush against the wall in the desired position.
Mark the center width of the mirror on the top edge of the mirror
frame with a pencil.
Set the mirror aside.
For Models K-2453, K-2456, K-2458, and K-2460 (for vertical
installations):
Measure and mark 4-1/4" (10.8 cm) down from the center width
mark. This mark is the center width for the hanger.
For Model K-18595 (for vertical and horizontal installations):
Measure and mark 2-3/4" (7 cm) down from the center width
mark. This mark is the center width for the hanger.
For All Models:
Hold the center of the hanger at the marked point for the hanger.
Make sure the largest side of the hanger is facing against the
wall, as illustrated.
Make sure the hanger is level, then drill through the pre-drilled
holes in the hanger. Use a drill bit that will accommodate the size
of the fasteners (not provided).
Kohler Co.
Hanger
Pre-Installed
Hanger
Hanger
Mirror
Finished Wall
3 1048842-2-B