CREE LIGHTING THE EDGE ARE-EDG-DA Instrucciones De Instalación

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical
code. If you are not familiar with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local.
Si vous n'êtes pas familier avec ces codes et ces exigences, veuillez contacter un
électricien qualifié.
3. When handling, hold fixture on sides to prevent damage to the top screen or LED's
4. Take care to keep the LED lenses clean during installation.
SAVE THESE INSTRUCTIONS FOR FUTURE
• Prior to installation, store luminaire in a dry location protected from rain, dust, and outdoor environment. If equipped with a photocell receptacle,
remove the protective cover only if immediately replacing with a suitable photocell, shorting cap, or other compatible device. The protective socket
cover is not intended to remain in place after installation. Do NOT leave receptacle open to environmental elements. Luminaires with a top-
mounted photocell receptacle should not be installed in an up-light position or at a tilt greater than 45 degrees from the down-light position.
TO INSTALL:
1
Fixture Arm
5/16 Lock Washer
Thru Hole
Threaded Hole
5/16 Lock Washer
MOUNTING
STEP 1:
Use dimensions on template shown in Figure 2 for drilling if pole is not
pre-drilled. (Template not to scale.)
STEP 2:
Insert Backing Plate with pre-assembled bolt through the top mounting
hole. See Figure 1.
STEP 3:
Place gasket over bolt extending from pole. See Figure 1.
1 of 3
INSTRUCTIONS
REFERENCE
Fixture Arm
Mounting Clip
Universal Mount Arm
Foam Gasket
5/16-18
SS Nut
Mounting Plate
5/16-18 SS Bolt
Threaded Thru Plate
5/16-18 SS Bolt
Includes: ARE-EDG-DA, ARE-EDG-DL, ARE-EDR-DA and ARE-EDR-DL
2
STEP 4:
Place the top hole of the Universal mounting arm over the top bolt from
the pole and secure with lock washer and 5/16" hex nut.
STEP 5:
Install remaining bolt with lock-washer thru the bottom hole and thread
into the Universal mounting arm. See Figure 1.
STEP 6:
Torque 5/16" hex nut and bolt to 132 in. lbs. (15 N•m).
Install fixture by sliding the fixture arm into the slot in the Universal
.
mounting arm. See Figure 1
THE EDGE
LED AREA DIRECT MOUNT
INSTALLATION INSTRUCTIONS
CI316X01R4_B
®