Drawer Removal; Automatic Icemaker - GE 16D3941P006 Manual Del Propietário

About storage drawer removal.
Not all features are on all models.
Drawer
Guides
When replacing the drawers, make
sure you slide them through both
drawer guides on the right side.
About the automatic icemaker.
A newly-installed refrigerator may take 8 to 12 hours to begin making ice.
Feeler arm
in the STOP
Icemaker
(up) position
Ice Storage Bin
Feeler arm
in the ON
(down) position
8

Drawer Removal

Drawers can easily be removed by tilting up
slightly and pulling past the stop location.
Remove the door bins from the fresh food door
before removing the drawers.

Automatic Icemaker

The icemaker will produce eight cubes per
cycle—approximately 120 cubes in a 24-hour
period, depending on freezer compartment
temperature, room temperature, number
of door openings and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
keep the feeler arm in the STOP (up)
position.
When the refrigerator has been connected
to the water supply, move the feeler arm to
the ON (down) position.
To remove the glass shelf above the top
drawer, first remove the top drawer and any
food on the shelf. Then reach in, push the
rear of the glass up until it touches the
bottom of the lower light shield. Then push
the shelf back approx. 1/2² (13 mm) until it
clears both the front corner retainers.
To replace the shelf, reverse these steps.
The icemaker will fill with water when it cools
to freezing. A newly-installed refrigerator may
take 8 to 12 hours to begin making ice cubes.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the swing of
the feeler arm.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes
will become cloudy and taste stale.