Change To The Edging Mode; Adjust The Length Of The Shaft; Maintenance; General Information - GreenWorks STF309 Manual Del Operador

EN
9.8

CHANGE TO THE EDGING MODE

The machine can be used in combination with the edge
guide for edging sidewalks and walkways.
1. Stop the machine and flip down the edge guide from
stored position.
2. Pull the edging coupler and turn the trimmer head 180
degrees until the trimmer head locks into position.
3. Release the edging coupler.
NOTE
English
9.9 ADJUST THE LENGTH OF THE
SHAFT
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Loosen the telescoping boom coupler (5) and move the
shaft to the desired position.
3. Tighten the coupler.
10

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
10
NOTE
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT